Roller brake testers (on ground) RT2002-LP22 / RT9002-LP22
Single bed roller brake tester for passenger cars, vans and light commercial vehicles. FOR ON FLOOR and/or OUTDOOR INSTALLATION. The PERFECT solution to position ON FLOOR in front of a 4-post lift or on its own in combination with hot dip galvanised RAMPS.
ONLY 22 cm HIGH!
In addition to measure the brake forces per wheel and the difference between the left and right sides of an axle, the operator can determine the important quantities rolling resistance, actuation force, ovality (out-of-roundness) and brake fading for each wheel.
Special attention has been given to prevent damage to the tires. The rollers quickly stop when slippage occurs, even during the start-up of the motors. All roller brake testers are equipped with reliable worm gear motors.
The brake efficiencies (decelerations) of the vehicle are calculated automatically after manual vehicle weight input and can be compared with legal requirements for the service- and parking brake.
- Advantages
-
- High quality.
- Reliable worm gear motors.
- Hot dip zinc chassis.
- Standard 4x4.
- Only 22 cm high.
- No damaged tires.
- Extensive analysis.
Specifications
- RT2002-LP22
-
Maximum axle load4000 kgMeasuring range8000 NMotor(s)2 x 5,5 kWRoller speed5 km/hRoller dimensions700 x 206 mmTrack800-2200 mmDimensions284 x 66 x 22 cm
- RT9002-LP22
-
Maximum axle load4000 kgMeasuring range8000 NMotor(s)2 x 5,5 kWRoller speed5 km/hRoller dimensions900 x 206 mmTrack800-2600 mmDimensions324 x 66 x 22 cm
- All models
-
FinishHot dip zincPower supply3PH 400 V / 50 Hz
- Brochure downloads
English
Nederlands
Français
Impression
